XIHADA Universal Garage Door Opener Remote and Gate Opener Remote Compatible Brands & Models:

XIHADA Universal Garage Door Opener Remote and Gate Opener Remote Compatible Brands & Models:

LIST of BRANDS & MODELS NOT COMPATIBLE WITH XIHADA

IMPORTANT NOTES ATTENTION: These brands can not be compatible with XIHADA Universal Remote: Liftmaster Security 2.0 Garage Door Opener/Chamberlain Garage door Opener with MYQ /Liftmaster Garage Door Opener with MYQ/LiftMaster 8500W Garage Door Opener/ Liftmaster 892LT/ LiftMaster 811LMX / LiftMaster 893LM / Chamberlain B 6713T Garage Opener/Chamberlain B 6753T Smart Garage Opener / Condo's garage door opener, Ryobi, Softens Doors, Blue Sea, Allister, Amarr, Atoms, Doorking/DKS, Lynx, Merik, Stanley, Skylink, Wayne Dalton, Martin, SACO Gate Opener.

Pls check carefully from the above two pictures for the XIHADA Universal Remote Compatible Brands & Models Original Remotes.

Pls check and make sure your gate opener / garage opener is listed as compatible as provided in these Compatibility List.

This Universal Remote is only compatible with these brands & models remote control.

XIHADA Universal Remote General Programming Steps:

1)Note, holding the universal remote with the keychain on the bottom First, for the entry gate.

2)On this universal remote, hold down button 1, and then press button 2 FOUR times.

3)Then release both buttons, The LED of universal remote emits a flash every 2 seconds, indicating that it is ready to start learning codes.

4)Place your original remote very close to the universal remote , or have your original remote back to back / face to face

touching the XIHADA universal remote, hold down your original remote's button that you want to copy, until the LED of

universal remote starts to flash quickly, indicating that it is now learning codes from your original remote.

5)While the LED of universal remote is flashing, press any button of the universal remote where you want to store,

the remote’s code just copied, until the led will turn off.

6)For the garage door openers, use the same process above. However, one more step is needed. The one more step is

– press the LEARN button on your garage door opener (the mechanical unit that opens the door).

The LED on your garage door opener should be ON.

7) Next, just press the same button you programmed on the universal remote. The lights on your garage door opener should

either flash or go on or off depending on the brand of the opener. Now you can use the universal remote to open your garage door.

8) If you have any question about the universal remote's programming, please send us Amazon email, we will reply you within 24 hours.