Specification: Item Type: Pressure Washer Foam Cannon Material: Premium Metal ABS Stainless Steel PE Weight: Approx. 1350g / 47.6oz Cannon: MAX 60°C/140°F, MAXIMUM 300bar/4350PSI, Working 150bar/2175PSI How to use: How to replace the foam: 1. Use pointed pliers to pull the wire out above the plastic-coated section. 2. Pull out the plastic coated part to separate; remove the metal fittings. 3. Replace the frother. 4. Install the plastic lining and insert it. How to replace the orifice nozzle: 1. Unscrew the plug from the 1/4 inch quick connector. 2. Use a slotted screwdriver to turn the nozzle of the foam cannon counterclockwise. 3. Tighten the new nozzle of the foam cannon. 4. Screw on the 1/4 inch quick connect plug. How to install the foam cannon: 1. Pour some soap into the bottle with pure water. 2. Insert the straw into the suction port. 3. Connect the 1/4" quick connect plug to the pressure washer or hose. 4. 4. Adjust the knob to the desired foam level. Next, adjust the plastic-coated portion 1 of the nozzle to the desired fan pattern. 5. Unlock the lever and it will disperse the thick foam. 6. 6. After cleaning, turn the knob to the ""+" side and spray non-foam water for 10 seconds to remove the remaining soap from the orifice nozzle and foam generator. Otherwise, the remaining soap will become clogged easily. Package List: 1 x Transparent Bottle 1 x Double Connector 7 x Spray Nozzle 1 x 1mm Replacement Copper Spray Core 1 x 3.7g Blow Net 1 x Anti-Clogging Needle 1 x Spray Cannon 1 x Instruction Manual 1 x Rubber Hose 1 x Foam Generator Note: Foam Cannon is available in