Be Careful:

• General application: When your driver is 7V-12V, you can enable the onboard 5V logic power supply. When using the onboard 5V power supply, the+5V power supply in the interface does not input voltage, but can absorb 5V voltage for external use.
• Unconventional applications of high-voltage drive: When the driving voltage is higher than 12V and less than or equal to 24V, such as driving a motor with a rated voltage of 18V, the jumper cap that opens the 5V output board voltage must be removed, and then the 5V voltage must be connected to the L298N internal logic voltage source outside the 5V output port.

There are two methods to reopen the system:

• Turn on the power switch on the back of the computer and wait for the power cover to discharge, as the relay will reset in the absence of power.
• After opening the hood and checking for faults, press the button on the relay. There is a red LED above for power supply, and a green LED indicating that the relay has been activated, so you can be very sure of its status. Whenever you try to hot wire the ATX power supply and need to switch functions in addition to the switch on the back, simply supply power from pin 9, connect the relay to pin 16, and of course, connect it back to the ground pin.

Product Size:

• Driver Board Size：55×60×30mm
• Driver Board Weight:33g
• Size: 43x43x27mm