Spec:
Item Type:Thread Sleeve
Material:Stainless Steel
Thread Insert Size:M14x1.5 Length:2D
Package List:
1 x Spiral Drill
1 x Screw Tap
1 x Wrench
1 x Break Pin Tool
1 x Hex Wrench
10 x Thread Repair Insert
Note:
Instructions
Drill holes using a matching drill bit.
Use wire threaded (special) tap tapping, the tapping depth must exceed the wire screw sleeve mounting length.
Insert the wire screw into the mounting wrench with the tail down. Turn the wrench handle to screw the wire screw into the threaded hole.
Use a break pin tool to align the mounting handle (tail) with a hammer to strike the punching tool and the tail handle can be removed.
When there is a problem with the installation of the threaded screw sleeve, (such as a jumper), the threaded sleeve can be taken out by the wire threading tool.
Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.