Specification: Size: 15.6FT length, 0.78 inch width, single layer thickness: 1.1mm Bearing weight: 20 pounds per inch longitudinally. Material: Foam Packing quantity: 1 roll Instructions 1. Before using the tape, please clean the adhesive part, keep the adhesive surface dry, and avoid dust, oil stains, moisture, etc. 2. Use scissors to cut the length you need (if it is used for larger and heavier items, such as photo frames, industrial crops, etc., use more according to the actual situation) 3. Stick the side without release paper on the adhesive surface, and then press it back and forth for 1 minute to make it firm 4. When using double-sided tape, apply force evenly from one end to the other to reduce the appearance of bubbles 5. After sticking the tape, let it stand for 24 hours before sticking the adhesive (if it is a heavy object, please keep standing for 72 hours, do not tear off the release paper to avoid dust and impurities) 6. Tear off the release paper, insert a needle or knife between the glue and the release paper, pry open a small hole, and then tear off the red release paper. Note: 1.The tape is not obvious to the touch after tearing off the release paper. This is the characteristic of tape glue.It needs a certain amount of force and continuous pressing to release its stickiness.so it is convenient for everyone to modify it when the wrong position is posted. 2. The tape will work best when it is pasted for 72 hours. Don't bear weight during this time. 3. The temperature in winter is low, if it feels not very sticky, it is recommended to use a hair dryer to heat it up. 4. Can not be used on litchi pattern surface, peeling, rough surface, or silicone material