Feature:
Works on 3/4" to 1-1/8" shaft diameters.
These make the puller tough and sturdy enough to achieve a good anti-corrosion and anti-rust effect.
Designed to remove 2, 3, and 4 blade propellers on inboard shafts. These tools have fine thread screws to enable a strong pulling force with little effort.
Specification:
Color: Black, Silver Tone
Material: Metal
Installation:
Remove the cotter pin. Loosen the prop nut twice (do not remove the nut).
Back out the prop puller bolt to allow for installation of the puller. Put the puller between the forward end of the prop hub and aft of the strut.
Tighten the puller bolt clockwise with a wrench. Don't tighten too much.
After the puller is firmly in place and the puller bolts are tightened, tap the opposite end of the puller with a hammer. Steps 3 and 4 May need to be repeated.
When reinstalling the propeller, a thin layer of grease or anti-tightening film can be applied to the shaft/hole taper, but do not apply too much. Also, do not tighten the support nut too much.
Package Includes:
1 x Inboard Propeller Puller