Feature:

This adjustable equipment allows you to return the strut to the original camber position after dismantling and re-assembling the suspension or to check the amount of camber change before re-installing.

Time and money saving device.

Easy to read and convenient to operate.

How to use:

1. Remove the wheel alignment sensor (Clip tool), remove the tire;
2. The magnetic level gauge carefully on the side of the suction wheel disc brakes;
3. The water level was adjusted to zero;
4. Install the required location specific parts;
5. Use a special tool, with the degree of magnetic level gauge indication, adjust the positioning of the part to the desired measurement angle.
6. Retest with locator If there is a little deviation, just to fine-tune the vehicle. (Usually a slight deviation does not cause fault location)