230° Pivoting Head

• Offering a continuous sweep through a usable 230° arc, the pivoting head lets you approach your work from any angle.
• Since there are no preset head positions, you can move fluidly around obstructions along the path of your handle swing.
• An internal spring controls the tension of the head, allowing it to hold its position while installing sockets and placing on fasteners.

Sleek, Comfortable Handle

We designed a sleek and simple handle that considers the many ways your hand interacts with the tool. Especially useful for a two-handed grip, the inside edge of the pommel is well-defined to keep your hands from slipping off the end of the handle, while its outer circumference is rounded, allowing you to comfortably apply as much force as needed.

Accurate Working Length

To be clear and consistent about the size of our breaker bars, we use the actual working length (center of drive tang to end of handle), not the overall length of the tool. This avoids any misleading overstatement of size or capability caused by the difference between these measurements.

Strong + Reliable

Our ratchets and breaker bars meet (and most far exceed) minimum industry standards for important baselines like Proof Torque, a measure of strength verified by a single-cycle test* that applies torque until the specified value is reached without failure or any permanent deformation.

*Both proof and fatigue torque specifications were approved by manufacturer on 8/8/2018